Day 225 – Hilbert cubes

Day 225 – Hilbert cubes

Day 225 – Hilbert cubes 640 480 mathgrrl

Today’s print is sushiyaki’s Hilbert block model on Thingiverse. This model is great because it prints without any supports at all, and some of the gaps between the paths even separate. There is also a natural slot that you can use to hold a business card or photo!

Thingiverse link: http://www.thingiverse.com/make:73667

Settings: MakerWare .3mm/low on a Replicator 2.

Stuff for the future: Bill Owens (owens on Thingiverse) has been thinking about making a Hilbert cube model that prints on its corner without the need for supports… stay tuned?

Leave a Reply

Back to top